CORODUR® SP 106

Flux cored wires for Thermal Spray Application

EN ISO 14919 – 5 – 1,6 - 4

MATERIAL REVIEW

Wire for thermal spray composed from tungsten carbide and titanium carbide within an amorphous matrix. The coating shows very good resistance against abrasion having high bond strength and good deposition rate. Designed for arc spraying but may also be sprayed by wire- and highvelocity- wire-flame-spraying

APPLICATION

Used as coatings to prevent sliding on industrial paths and on deck of ship.

COMPOSITION (Weight-% )

Fe	Cr	Ni	Si	Mn	WC	B	Ti₂C₃
Bal.	14	4,5	1,3	0,6	26	1,9	6

PHYSICAL PROPERTIES OF THE COATING

Hardness: 64-69 HRc
Melting point: ca 1200 °C
Density: 6,75 g/dm³
Spray rate: 2,9 kg/h / 100 A
Wire consumption 1,2 kg/m² / 0,1 mm

SPRAY PROCEDURE (Arc)

	Atomizing Air Pressure	Nozzle Cap	Arc Load Volt	Ampere	Stand off mm	Coating thickness / pass mm/pass	Deposit Efficiency %
Standard 1,6	4,1 bar		30-32	100-200	75-125	0,125	70%

SALES UNIT

Coil	"BS 300" = 15 kg	"BS 450" = 25 kg	Other dimensions on request
Wire diameter	1,6 mm (1/16")	2,4 mm

Corodur Fülldraht GmbH may change the characteristics of the wire without notice. Statements on composition and application are just
for the applier’s information. Statements on mechanical properties always refer to the all-weld-metal according to valid standards. We
recommend the applier to check our products for their special application autonomously.

PDF Factsheet